Walton MH17 flash file

 Walton MH17 flash file

Flashing a device with SPD6531E chipset typically involves using a flashing tool compatible with Spreadtrum (SPD) chipsets. Here's a general guide on how to flash a device with SPD6531E chipset:

1. Download Required Files:

   • Firmware/Stock ROM for your specific device model.
   • SPD Upgrade Tool or any other flashing tool compatible with SPD chipsets.
   • USB drivers for Spreadtrum (SPD) chipset.

2. Install USB Drivers:

   • Install the USB drivers for Spreadtrum chipset on your computer. These drivers enable your computer to communicate with your device when connected via USB.

3. Extract Firmware:

   • Extract the firmware/stock ROM file that you downloaded earlier. You'll typically find a scatter file and other firmware files within the extracted folder.

4. Install Flashing Tool:

   • Install the SPD Upgrade Tool or the flashing tool you've chosen on your computer.

5. Launch Flashing Tool:

   • Open the flashing tool on your computer.

6. Load Firmware:

   • In the flashing tool, locate and load the scatter file from the extracted firmware folder.

7. Prepare Your Device:

   • Remove the battery from your device if it's removable. If not, ensure your device is powered off.

8. Connect Your Device:

   • Connect your device to your computer using a USB cable. If possible, use a good quality USB cable and connect directly to a USB port on your computer rather than through a USB hub.

9. Start Flashing:

   • Once your device is connected and detected by the flashing tool, you can start the flashing process. This usually involves clicking on a "Start" or "Download" button in the flashing tool.

10. Flashing Progress:

    • The flashing tool will start flashing the firmware to your device. You'll see a progress bar indicating the status of the flashing process. Do not disconnect your device during this process as it may brick your device.

11. Completion:

    • Once the flashing process is complete, you'll see a "Finish" or "Success" message in the flashing tool.

12. Disconnect Your Device:

    • After the flashing process is complete, disconnect your device from the computer.

13. Restart Your Device:

    • If your device doesn't restart automatically, manually restart it.

14. Set Up Your Device:

• After restarting, set up your device as you normally would after a factory reset.

1. Download